Publicité
NOTE
32
PROGRAMMING
Enter into programming mode
>
Step 1: Press the "mode" push button until Prog led is blinking.
>
Step 2: Press "validation" push button. PROG led becomes fixed and access code is displayed.
>
Step 3: Enter access code (1000 factory default) using keypad "left", "right", "top" and "bottom".
>
Step 4: Press "validation" push button to enter programming mode.
Programming mode exit
>
Step 1: Press the "ESC" push button when not entering any value, to come back to main programming menu.
>
Step 2: Press again on "ESC" push button to exit programming.
New Active mode (Automatic or Manual) depends
on information from the master device.
Navigation in programming mode
>
Step 1: To access required menu, press navigation push buttons "left" and "right".
>
Step 2: To access parameter to modify press navigation push buttons "top" and "bottom".
>
Step 3: To modify the parameter, press push button "right" to make the required parameter blinking.
>
Step 4: Press push buttons "top" and "bottom" to increment or decrement the value of the parameter.
>
Step 5: Press "validation" push button to validate.
>
In case of parameter displayed on 2 lines, press "validation" push button after first line modification to
access next one.
>
"ESC" push button allows to come back to main menu or to cancel the modification.
33
Publicité
