Siemens SCALANCE X-300 V4.1.8 Manuel De Configuration page 411

• C-PLUG removed at runtime.
• C-PLUG plugged in at runtime.
• RMON rising alarm occurred.
• RMON falling alarm occurred.
• Ring redundancy enabled.
• Ring redundancy disabled.
• (R)STP protocol enabled.
• (R)STP protocol disabled.
• Disabled (R)STP because ring redundancy is enabled.
• DIP settings taken from C-PLUG.
RM=<ON|OFF>, STBY=<ON|OFF>, R1=<ON|OFF>, R2=<ON|OFF>
• (R)STP topology change detected while (R)STP is off. Aging time will be reduced to <Zeit in
s> sec for at least <Zeit in s> sec.
• Set aging time back to original value <Zeit in s> sec.
• No connection to SNTP server. Server IP address <adresse IP>.
• Connected to SNTP server. Server IP address <adresse IP>.
• Enabled link status monitoring on ring ports.
• Changed port VLAN ID of the ring ports to 1.
• Disabled GVRP because ring redundancy is enabled.
• Disabled GMRP because ring redundancy is enabled.
• Disabled mirroring because monitor port is ring port.
• (Re)enabled ring ports (because disabled by user).
• Disabled port lock on ring ports.
• Warning: ring ports have different static VLAN configuration.
• Warning: ring ports have different VLAN port configuration.
• Warning: ring ports have different static multicast configuration.
• Warning: ring ports have different load limits configuration.
• Enter fault state: port <numéro de port> enabled for link status monitoring and link down.
• Leave fault state: port <numéro de port> disabled for link status monitoring.
• Enter fault state: power line <ID de l'alimentation> enabled for power monitoring and power
down.
• Leave fault state: power line <ID de l'alimentation> disabled for power monitoring.
• <CLI | WBM | SSH>: Authentication failure.
• Warning: OSPF consumed too much memory and is shut down.
• Duplicate IP address <adresse IP> sent from <adresse MAC>
• IN <numéro de l'entrée TOR> (<nom de l'entrée>) <high | low>
SCALANCE X-300/X408-2 V4.1.8 / SCALANCE X414-3E V3.10.2
Manuel de configuration, 07/2024, C79000-G8977-C187-35
D.1 Messages d'erreur du SCALANCE X300 / X400
Annexe D
411