Publicité
Optional wiring
Addendum: wiring inline power adapters
1. To wire multiple adapters, first remove the wiring tray from the cart by releasing the levers on
the tray slides and pulling the tray completely out.
2. On the first 10 adapters, measure 19" of length on the low voltage side. Figure 10A.
3. On the second 10 adapters, measure 11" of length on the low voltage side
4. Bundle the remaining low voltage power cord and secure tightly with a zip tie or Velcro strip.
5. Bundle the high voltage cord the same way. Power cord length can vary as long as ther is
enough length to pull the tray out.
Approximately 19"
[48.5 cm]
Low voltage power cord
6. Lay the inline power adapters flat on the tray and stagger them as shown. Figure 10B.
7. Route the low voltage power cords through the openings at the edge of the tray.
8. Use Velcro strips or zip ties and the cord management cutouts to secure the cords to the tray.
9. Re-install the tray into the cart after all wiring is complete.
Câblage en option
Charge cord
bundle
approximately 11"
[28 cm]
Low voltage power cords
120V high voltage power cords
Inline
adapter
Charge cord
bundle
Inline
adapter
Figure 10A
Ilustración 10A
Cableado opcional
Note: Cord lengths may need to be
adjusted depending on the size of the
device and location of the charge port
on the device.
120V high voltage
power cord
Wiring tray
Figure 10B
Ilustración 10B
0110116R8 Page 10 of 22
Publicité
