Publicité
APPLICATION :
This pump is designed for shallow well
installation for water level up to 25 feet.
CAPACITY AT 20 PSI :
25'
350 US GPH
20'
490 US GPH
15'
650 US GPH
10'
775 US GPH
5'
905 US GPH
Friction loss in pipe
not included.
We recommend that you install your pump in a clean and dry location
STEP 1
where there is adequate room for servicing at a later date. Protection
from freezing temparatures and good ventilation should be considered
as well, to provide the pump an environment for long life. Locating the
pump as close as possible to the water source will reduce friction losses
encountered in the suction pipe.
Friction losses in the suction pipe must be taken into consideration when
the horizontal offset is greater than 50 feet. The suction pipes should be
increased from 1'' to 1 1/4''. This will reduce friction losses and allow the
pump to give maximum performance.
A new well should be checked to determine that it is free from sand. Sand
will damage the seal and the impeller. Have your well driller clean the well
before your installation.
Never run the pump dry. Damage to the seal may occur. Fill pump body
and suction pipe with water before turning on the power.
THE RUN OF THE HORIZONTAL PIPE FROM THE TOP OF YOUR
WELL INTO THE HOUSE, WHERE YOUR PUMP WILL BE LOCATED,
MUST BE INSTALLED IN A TRENCH, BELOW THE FROST LEVEL OF
YOUR AREA.
INSTALLATION STEPS
NEVER RUN THE PUMP DRY
FEATURES :
304 stainless steel pump body, easy
to prime.
Totally enclosed, fan-cooled motor.
Bearing to bearing. Built for continuous use.
Full-time connected run capacitor, to
eliminate starting wear vs regular motor.
Thermal and overload protection.
Noryl impeller, built-in injector.
1 HP, 115/230V AC, 60Hz, 9.0/4.5A
(18.0/9.0A when the pump start).
3
Publicité
