Publicité
This fine pump that you have just purchased is designed from the latest in material
and workmanship. Before installation and operation, we recommend the following
procedures :
Check with your local electrical and plumbing codes to ensure you comply with the
A
regulations. These codes have been designed with your safety in mind. Be sure
you comply with them.
We recommend that the pump be used on a separate circuit lead from the home
B
electrical distribution panel , and which is protected with a fuse or a circuit breaker.
The motor must be securely plugged into a proper 'GFCI' electrical outlet. Consult
a licensed electrician for all wiring.
The ground terminal on the three prong plugs should never be removed. They are
C
supplied and designed for your protection.
Never make adjustments to any electrical appliance or product with the power
D
connected. Do not only unscrew the fuse or trip the breaker, remove the power
plug from the receptacle.
MONTHLY MANDATORY CHECK-UP :
1. Inspect the pump for any obvious condition that necessitates cleaning, correction, adjustment or repair.
2. Clear the surroundings of any paper, leaves or other debris.
3. Ensure that the pump is secure for proper operation.
4. Ensure that there is adequate clearance from any combustible materials or structure. Stored
materials must be kept away from the pump. Shelves or cabinet structures must not be in close
proximity to the pump.
5. Ensure that the motor is securely plugged into a proper 'GFCI' electrical outlet.
6. Test the 'GFCI' outlet by pressing its test switch. This should prove that the outlet is energized and
will trip off to protect against a ground fault. Be sure to reset the 'GFCI' by pressing its reset switch.
7. Observe that the plumbing can carry the water safely into the residence.
Material required for drilled well application
Shallow well pump installation
Desired length of polyethylene 1'' pipe, 100 PSI, CSA
or UL approved, to link up from pumping level to pump.
1 1'' foot valve (750756 or 750752P).
1 well seal, as per well casing diameter (750929 6'' x 1'').
1 1'' well seal elbow (750860).
2 1'' male adaptors (750865 or 750871).
8 1'' stainless steel clamps (750885).
Teflon tape.
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist
in pipe cutting, round file to smooth pipe ends, pipe
wrench, adjustable wrench to tighten fittings.
2
SAFETY INSTRUCTIONS
(indoor use only)
Tank installation
Desired length of 1'' braided hose (750919)
to link up from pump to tank. Keep tank as
close as possible from pump.
1 tank T (650651).
1 drain valve (650659).
2 1'' female adaptor.
1 1'' male adaptor (750865 or 750871).
3 1'' stainless steel clamps (750885).
Teflon tape.
NOTICE
This unit is not designed for applications
involving salt water or brine. Use with
salt water or brine will void warranty.
Publicité
