Publicité
Installation Instructions
Adjusting the door Opening Angle
By factory default, the door opens by 95 degrees. You can use the limiter pin to adjust
the opening angle down to 90 degrees, depending on the installation conditions.
• Open the door to less than 90 degrees, and then completely insert the limiter pin
through the top and bottom holes of the top hinge as shown in illustrations (1) and (2).
• Close the door and make sure the limiter pin does not interfere with the hinge cover.
CAUTION
• Insert the limiter pin before putting the under counter refrigeration into the cabinet.
• If the limiter pin is not inserted completely, the hinge and the hinge cover may get
damaged.
95°
Factory default 95°
Cleaning
• Remove the protective vinyl.
• Wash the outside cabinet with warm water and a mild liquid detergent. Rinse well and
wipe dry with a clean, soft cloth.
• Wring excess water out of the sponge or cloth when cleaning around the controls or
any electrical parts.
36
English
Dacor_BRW5500D_IM_EN.indd 36
Limiter pin
With limiter pin 90°
Insert
Completely
2/32"
(2 mm)
90°
2024-06-13
4:31:43
Publicité
