Publicité
1
2
3
4
5
1
122
EN
6
7
8
9
10
2
Product overview
1x
1
Grinding guard
2
Cutting guard
3
Auxiliary handle connector
4
Outer flange
5
Inner flange
Using the tool
1x
1. Make sure your workpiece can not slip
and hold the tool firmly at the main han-
dle 8.
2. To switch on the tool, push safety lever
forward and press the on / off switch 8.
3. Let the tool run at no-load speed for about
a minute and check if the installed wheel
runs flawlessly.
1x
Grinding:
Caution! Only use grinding
wheels (thickness 6 - 8 mm) for
grinding.
The best grinding results can be achieved
with a 30° to 40° approach angle. Move
the tool back and forth with moderate
pressure.
DE
Lieferumfang
FR
Etendue de livraison
IT
Materiale compreso nella fornitura
NL
Leveringsomvang
SV
AUXILIARY HANDLE
Leveransomfång
1
The auxiliary handle can be attached
CZ
to the auxiliary handle
Rozsah dodávky
connector 3
either side of the tool.
SK
Rozsah dodávky
Caution! Make sure the tool is
RO
switched off and unplugged.
Volumul livrat
GB
Scope of delivery
Adjustments
1x
6
Safety lever
7
Power cord
8
On / Off switch
9
Main handle
10
Spindle lock button
1x
Cutting:
Caution! Only use cutting
6
wheels (thickness 2 - 4 mm) for
cutting.
When cutting, do not press, tilt or oscil-
late the tool. Gently slide it forward with
a speed adapted to the material being
worked on.
The tool must always work opposite to
the direction of rotation, otherwise there
is danger of being pushed out of the cut in
an uncontrolled way.
4. To switch off the tool, release the on / off
switch 8.
2
Screw the auxiliary handle into the
on
auxiliary handle connector 3.
For safe working conditions, make
sure the auxiliary handle is always
mounted to the tool.
EN
123
Publicité
