Publicité
The door is difficult to open
Explosion
Hazard
Use nonflammable
cleaner.
Failure
to do so can result
in death,
explosion,
or fire.
•
Gaskets
dirty or sticky? Clean gaskets
and contact
surfaces
with mild soap and warm water. Rinse and dry with soft cloth.
Temperature is too warm
•
New installation?
Allow 24 hours following
installation
for the
refrigerator
to cool completely.
•
Door opened
often
or left open?
Allows warm air to enter
refrigerator.
Minimize
door openings
and keep door fully closed.
•
Large
load of food added?
Allow several hours for refrigerator
to return to normal temperature.
•
Control(s)
set correctly
for the surrounding
conditions?
Adjust the control(s)
a setting
colder. Check temperature
in
24 hours. See "Using the Control(s)."
There is interior moisture buildup
NOTE: Some moisture
buildup
is normal.
•
Humid
room?
Contributes
to moisture
buildup.
•
Door opened
often
or left open?
Allows humid air to enter
refrigerator.
Minimize
door openings
and keep door fully closed.
The ice maker is not producing ice or not enough ice
•
Refrigerator
connected
to a water
supply and the supply
shutoff valve turned on? Connect
refrigerator
to water supply
and turn water shutoff valve fully open.
•
Kink
in the water
source
line? A kink in the line can reduce
water flow. Straighten
the water source line.
•
Ice maker
turned
on? Make sure wire shutoff arm or switch
(depending
on model) is in the ON position.
•
New installation?
Wait 24 hours after ice maker installation
for
ice production
to begin. Allow 3 days to completely
fill the ice
container.
•
Large
amount
of ice recently
removed?
Allow 24 hours for ice
maker to produce
more ice.
•
Ice cube jammed
in the ice maker
ejector
arm?
Remove
ice from the ejector arm with a plastic utensil.
•
Reverse
osmosis
water
filtration
system
connected
to your
cold water
supply?
This can decrease
water pressure.
See
"Water Supply
Requirements."
The ice cubes are hollow or small
NOTE: This is an indication
of low water pressure.
•
Water shutoff
valve not fully open?
Turn the water shutoff valve
fully open.
•
Kink
in the water
source
line? A kink in the line can reduce
water flow. Straighten
the water source line.
•
Reverse
osmosis
water
filtration
system
connected
to your
cold water
supply?
This can decrease
water pressure.
See
"Water Supply
Requirements."
•
Questions
remain
regarding
water
pressure?
Call a licensed,
qualified
plumber.
Off-taste, odor or gray color in the ice
New plumbing
connections?
New plumbing
connections
can
cause discolored
or off-flavored
ice.
Ice stored
too long?
Discard ice. Wash ice bin. Allow 24 hours
for ice maker to make new ice.
Odor transfer
from
food?
Use airtight,
moisture
proof
packaging
to store food.
Are there
minerals
(such as sulfur)
in the water?. A water filter
may need to be installed to remove the minerals.
ACCESSORIES
To order replacement
filters, call 1-800-901-2042
and ask for the part
number
listed below or contact
your authorized
Whirlpool
dealer. In
Canada,
call 1-800-807-6777.
Stainless
Steel Cleaner
and Polish:
Order Part #4396095
15
Publicité
