Publicité
Style 2 -Trivets
?4:s_'t _:}m® m_J@ s}
To remove and replace
the racks/bins:
1.
Remove the rack/bin
by lifting it and pulling it straight out.
2.
Replace the rack/bin
by sliding it in above the desired
support
and pushing
it down until it stops.
IMPORTANT:
For models
with a water filter, after connecting
the
refrigerator
to a water source or replacing
the water filter, fill and
discard
three full containers
of ice to prepare the water filter for use.
Turning the Ice Maker On/Off
To turn the ice maker ON, simply
lower the wire shutoff arm.
To manually
turn the ice maker OFF, lift the wire shutoff arm to the
OFF (arm up) position
and listen for the click.
NOTE: Your ice maker has an automatic
shutoff. As ice is made, the
ice cubes will fill the ice storage
bin and the ice cubes will raise the
wire shutoff arm to the OFF (arm up) position.
Do not force the wire
shutoff arm up or down.
(on scsq® m(>¢_®_}
To remove and replace
the utility compartment:
1.
Remove the utility compartment
by raising and holding
the cover
up while lifting the utility compartment
up and pulling it straight
out.
2.
Replace the utility compartment
by sliding it in above the desired
support
and pushing
it down until it stops.
To remove and replace
the can caddy:
1.
Hold the can caddy with one hand and pull up until it is released
from the door liner. Then, pull up on the caddy again, until the
stoppers
have been overcome.
2.
Pull the can caddy straight
out to remove
it from the door.
3.
Replace the can caddy by aligning the grooves on the sides with
the pins in the door liner. Push up on the bottom
of the caddy
until the stoppers
have been overcome,
and slide it fully into the
compartment.
Ice Storage Bin
1,
2.
3,
Wash the ice storage
bin with mild soap and warm water.
Slide the ice storage
bin under the ice maker, and push it toward
the back as far as it will go.
Lower the arm on the ice maker to the "on" position.
NOTE:
It usually takes approximately
24 hours for the ice maker
to begin producing
ice. You may notice the ice has an "off-taste."
If so, discard
the first three batches
of ice produced.
After that
the "off-taste"
should
be gone.
Ice Production Rate
The ice maker should
produce
approximately
8 to 12 batches
of
ice in a 24-hour
period. Allow 3 days to completely
fill the ice
container.
To increase
ice production,
lower the freezer and refrigerator
temperature.
See "Using
the Control(s)."
Wait 24 hours between
adjustments.
Remember
•
The quality of your ice will be only as good as the quality
of the
water supplied
to your ice maker. Avoid connecting
the ice maker
to a softened
water supply. Water softener
chemicals
(such as
salt) can damage
parts of the ice maker and lead to poor quality
ice. If a softened
water supply cannot
be avoided,
make sure the
water softener
is operating
properly
and is well maintained.
•
Do not use anything
sharp to break up the ice in the bin. This can
cause damage
to the ice storage
bin and the dispenser
mechanism.
•
Do not store anything on top of or in the ice maker or ice storage
bin.
12
Publicité
