Publicité
10. Insert the hex-head
bolts from the bottom
and start the self-
Lower Rear Corner
locking
nuts for each caster.
B
A. Self-locking
nut
C. _6-- 18 x _" Hex-head bolt
B. Caster bracket
D. Caster
11. Hold the head of the hex-head
bolts with a wrench
while
tightening
the self-locking
nuts with a socket
wrench.
12. Using a W' socket
wrench,
remove the four unit bolts (two on
each side) from the lower front and rear of the refrigerator.
NOTE:
Do not remove
leveling bolt.
Lower Front Corner
A
A. Leveling bolt (do not remove)
B. Refrigerator/freezer
unit bolt
13. Place the slot in the rear of the caster bracket
over the unit hole
in the rear of the refrigerator.
Align the hole in the front of the
caster bracket with the unit hole in the front of the refrigerator.
A. Refrigerator/freezer
rear unit hole
B. Caster bracket
14. Hold the bracket
in place and insert the unit bolts into the front
and rear unit holes and tighten.
NOTE:
Do not overtighten
the bolts.
15. Insert two of the 1A--20 x 1V4" self-tapping
hex-head
bolts and
lock washers
into the two holes in the side of the caster bracket.
Push the caster bracket
against
the bottom
of the refrigerator
and tighten the bolts using a 3/8" socket
wrench.
A. Caster bracket holes
16. Repeat steps 12 to 15 for the other caster bracket.
Complete the Installation
1.
Lock the front casters.
NOTE:
Locking
the casters
will help prevent the refrigerator
from
moving
while it is being lifted.
2.
Insert a small piece of cardboard
between
the caster brake and
the floor. This will help prevent the brake from rubbing
on the
floor.
3,
4.
5,
6.
Stand the refrigerator
upright.
Replace the base grille by placing
the metal clips in the openings
in the metal panel and rolling the grille downward
until it snaps
into place.
Unlock
the casters
and move the refrigerator
into its final
location.
Lock the casters.
Publicité
