Publicité
APPLICATION :
Designed for a permanent installation
on auxilliary back-up emergency pump
on the submersible or column
water-out system.
Capacity :
4'
1600
8'
1200
10'
1020
MATERIAL REQUIRED FOR BATTERY BACK-UP SUMP PUMP APPLICATION
Pump installation
- Desired lenght of cooper pipe and adaptor or fitting, to link up
emergency pump to the discharge of the principal electrical
sump pump.
- Teflon tape.
- Desired lenght of polyethylene pipe and T or Y fitting, to link up
emergency discharge to existing evacuation pipe.
Tools
- Screwdrivers, hacksaw to cut pipe, knife to assist in pipe
cutting, round file to smooth pipe ends, pipe wrench,
adjustable wrench, adjustable wrench to tighten fittings,
propane torch and welding material.
Battery
Use only a new fully charge 12 Volt deep cycle battery. Electrolyte
level must be checked and maintain in accordance with manufacture's
guideline.
Battery sizes that will fit into the battery box are 24C, 24CM, 27C,
27CM, and 27F.
Battery recharge time will be different at each installation. Under
normal conditions it will take two to four days to bring a deep cycle
battery back to full charge after it has been discharged. If electrical
power to the house is lost more than once a week, consider keeping
a spare, fully-charged battery to replace an exhausted battery for the
standby sump pump.
FOR INFORMATION | TEL : 514.337.4415 | FAX : 514.337.4029
Friction loss
US GPH
in pipe not
US GPH
included.
US GPH
FEATURES :
12V DC motor.
Easy to combine on any kind of sump pump.
Automatic flapper valve activated.
Any electrical circuit required.
Battery life :
- 7 HOURS at
- 9 HOURS at
- 10 HOURS at
4' (1.2m)
8' (2.5m)
10' (3.0m)
3
Publicité
