Publicité
SAFETY INSTRUCTIONS :
This fine pump that you have just purchased is designed from the latest in
material and workmanship.
Before installation and operation, we recommend the following procedures:
Check with your local electrical and plumbing codes to ensure you
A
comply with the regulations. These codes have been designed
with your safety in mind. Be sure you comply with them.
We recommend that a separate circuit have to be lead from the
B
home electrical distribution panel properly protected with a fuse
or a circuit breaker. We also recommend that a ground fault
circuit be used. Consult a licensed electrician for all wiring.
The ground terminal on the three prong plugs should
C
never be removed. They are supplied and designed
for your protection.
Never make adjustments to any electrical appliance or
D
product with the power connected. Do not only unscrew
the fuse or trip the breaker, remove the power plug
from the receptacle.
During the installation steps, should be sure than the basement
E
is free of moisture or any fluid or water.
Battery acid corrosive. Avoid spilling on skin or clothing. Eye
F
protection must be worn when handling the battery.
Assuming that you have a sump pit located in your basement
G
floor. Your sump pit should be constructed from concrete, brick,
tile or more recently a sump basin made from plastic and/or
fiberglass. The minimum size of your sump pit must be 18'' in
diameter and no less than 25'' deep. When pit is ready, proceed
to next step.
This pump must only be used to pump clear water. This pump is not designed to
handle effluent, salt water or brine. Should be not used also on laundry discharge or
any chemicals fluids.
Pump damage may occur if used in these applications and will void warranty.
2
FOR INFORMATION | TEL : 514.337.4415 | FAX : 514.337.4029
(applicable to your electrical primary pump)
WARNING
Publicité
