Publicité
This fine pump that you have just purchased is designed from the latest in material
and workmanship. Before installation and operation, we recommend the following
procedures:
Check with your local electrical and plumbing codes to ensure you
A
comply with the regulations. These codes have been designed with
your safety in mind. Be sure you comply with them.
We recommend that a separate circuit have to be lead from the home
B
electrical distribution panel properly protected with a fuse or a circuit
breaker. We also recommend that a ground fault circuit 'GFCI' be used.
Consult a licensed electrician for all wiring.
The ground terminal on the three prong plugs should never be removed.
C
They are supplied and designed for your protection.
Never make adjustments to any electrical appliance or product with the
D
power connected. Do not only unscrew the fuse or trip the breaker,
remove the power plug from the receptacle.
For pumping systems using more than one pump, each pump needs to be connected
to a separate dedicated circuit protected by a fuse or breaker. This way, the power
supply of one pump will not stop operating if the fuse of one of the pumps burns or if the
breaker of one of the pumps trips.
Material required for sewage pump application
Desired length of ABS/DWV 2'' pipe, to link up from pump discharge to waste or drain
existing pipe.
Required quantities of 2'' ABS/DWV elbow(s) and/or other fitting(s) to run the discharge line.
1 only 2'' ABS/DWV male adaptor to 2'' slip, to connect the discharge pipe to the pump.
Desired length of ABS/DWV 3'' pipe and required quantities of 3'' ABS/DWV elbow(s) and/or
other fitting(s) to run the vent line.
1 only 2'' union check valve # 450457.
1 only 18'' X 30'' minimum size sewage basin like # 450448.
Teflon tape and ABS cement.
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench adjustable wrench, 1/2'' drill bit and drill. Ensure that you have a gas tight
cover for your sewage basin and 3'' ABS/DWV vent piping.
This unit have been designed to pump water only. This unit is not designed for applications involving salt water, brine or
any other liquids including petroleum products. Use with salt, brine or any other liquids including petroleum products will
void the warranty.
SAFETY INSTRUCTIONS
ELECTRICAL CONNECTION
NOTICE
2
Publicité
