Publicité
FOREST MASTER
STEP 3:
Begin cutting the logs by
sawing the overhanging ends
to the required length of log
then saw down between the H
sections.
If the overhanging ends need
to be cut into multiple logs
then cut alternately from
each end in order to keep the
weight over the centre of the
stand.
It is important that the bumper spikes on the chainsaw are in contact with
the logs before starting to cut. This is to avoid kickback and also to avoid
pulling the sawhorse over.
10
1
3
4
2
Bulk Log Sawhorse (BLS-3H)
IMPORTANT: Please read these instructions carefully. Note the
safe operational requirements, warnings & cautions. Use the
product correctly and with care for the purpose for which it is
intended. Failure to do so may cause damage and/or personal
injury and will invalidate the warranty. Please keep these
instructions safe for future use.
IMPORTANT SAFETY INFORMATION
Before using the log stand always check that all nuts and bolts are secure
and that the log stand is not damaged.
Use the log stand on firm level ground only. Do not use on sloping or uneven
ground.
After securing the logs in the log stand, check the stability and balance be-
fore starting to cut. The log stand must not be able to tilt.
Read and observe the operating instructions of the chainsaw you are using
and wear all recommended safety gear. Always wear safety shoes or boots
in case a log is accidentally dropped on your feet.
Only cut with the bottom of the chainsaw bar as the log may otherwise shift
away from the rotating chain, become unstable and increase the risk of per-
sonal injury.
Clear and stack the sawn logs away from the log stand to keep the work area
clear of obstructions and safety hazards.
IMPORTANT: Check that the logs are secure and the log
stand is stable before beginning to cut.
WARNING: Do not exceed the specified maximum total
log weight as given on page 2 of this manual.
Bulk Log Sawhorse (BLS-3H)
FOREST MASTER
11
Publicité
