Publicité
FOREST MASTER
Step 1:
Attach three Base Clamps(2), to each of the Base Planks(1). The
clamps should be mounted on the side without the markings and
with the thumb screws locating on the top of the plank.
Position one clamp in the centre of the plank between the 0 marks.
Position the outer two at suitable positions, to get the required final
log length when the logs are sawn centrally between the uprights.
Fasten the clamps in place by tightening the thumb screws.
6
Bulk Log Sawhorse (BLS-3H)
Step 2:
For each Base Board assembly
from Step 1, insert the Upright
Tubes(5) up through the clamps,
so that the clamps rest on the
rubber feet of the tube.
Bulk Log Sawhorse (BLS-3H)
FOREST MASTER
7
Publicité
