HBM SCM-HV Guide Rapide page 7

SCM-HV
maximum permissible values specified in the SCM­HV
data sheet.
S The signal conditioner must not be modified from the
design or safety engineering point of view except with
our express agreement. In particular, any repair or
soldering work on motherboards (replacement of com­
ponents) is prohibited. When exchanging complete
modules, use only original parts from HBM.
S The signal conditioner is delivered from the factory
with a fixed hardware and software configuration.
Changes can only be made within the possibilities
documented in the manuals.
S The signal conditioner is maintenance free.
S Please note the following when cleaning the housing:
- Disconnect the signal conditioner from all current
and voltage supplies.
- Also switch off the feeding QuantumX module.
- Clean the housing with a soft, slightly damp (not
wet!) cloth. Never use solvent as this could damage
the labeling or the housing.
- When cleaning, ensure that no liquid gets into the
signal conditioner or onto the connections.
- Give the SCM-HV sufficient time to dry before start­
ing it up again.
S The signal conditioner must be stored in dry, closed
rooms. If the signal conditioner has been transported
at extreme temperatures, you should wait for at least
2 hours to allow the signal conditioner to acclimatize,
before switching it on.
S In accordance with national and local environmental
protection and material recovery and recycling regula­
tions, old signal conditioners that can no longer be
A3615-4.0 HBM: public
Safety instructions
5