HBM SCM-HV Guide Rapide page 9

SCM-HV
S The signal conditioners and devices of automation
must be blocked in such a way that adequate protec­
tion or locking against unintentional actuation is pro­
vided (e.g. access checks, password protection, etc.).
S If the SCM­HV is operated on QuantumX modules,
additional safety precautions must be taken in terms
of both hardware and software for signal conditioners
working in networks, so that a line break or other in­
terruptions to signal transmission do not cause unde­
fined states or loss of data in the automation device.
S After making settings and carrying out activities that
are password-protected, you must make sure that any
controls that may be connected remain in a safe con­
dition until the switching performance of the signal
conditioner has been tested.
Additional safety precautions
This signal conditioner is built and tested in accordance
with EN 61010, Safety Requirements for Electrical Equip­
ment for Measurement, Control and Laboratory Use, and
was in perfect condition when it left production. To main­
tain this condition and ensure risk-free operation (reduc­
ing residual risks, EN 61010­1:2010 17 c), the user must
comply with the instructions and warning notices con­
tained in this operating manual.
Additional safety precautions to meet the requirements of
the relevant national and local accident prevention regu­
lations must be taken in plants where malfunctions could
cause major damage, loss of data or even personal in­
jury.
The scope of supply and performance of the signal con­
ditioner covers only a small area of measurement tech­
nology. Before starting up the signal conditioner in a sys­
tem, a project planning and risk analysis must first be
A3615-4.0 HBM: public
Safety instructions
7