Publicité
INSTALLATION INSTRUCTIONS
TOOLS NEEDED:
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
•
Hand drill or electric drill
•
Scissors
(properly grounded)
•
Masking tape
•
_/2"Brad point doweling
drill bit
•
Tape measure
•
Phillips screwdriver
•
Petroleum jelly
PARTS NEEDED:
Custom Overlay Frame--See
"Overlay Frame--Rear
View."
Hardware (Optional)
PARTS SUPPLIED:
•
Flat-head screws (8)
•
Overlay plates (2)
•
Round-head
screws (8)
•
Overlay hooks (4)
If you plan to install a custom overlay frame, you will need to
create the frame yourself or consult a qualified cabinetmaker
or
carpenter. See dimension drawings for frame specifications.
IMPORTANT:
•
The thickness of the overlay frame must be 3/4" (1.91 cm).
•
Overlay frame must not weigh more than 10 Ibs (4.54 kg).
•
Overlay frames weighing more than recommended
may
cause damage to your appliance.
Overlay
Frame--
Rear View
Create the custom overlay frame using the dimensions shown.
A
15_6 ''
(3.33 crn)
413/32"
2.95"
(11.2 cm)
(7.6 cm)
2.95"
(7.5 era)
(6.4 cm)
23.62"
(60.0 cm)
A. Overlay
hook
locations
297/8 ''
(76.66 cm)
Install Overlay Hooks
Using a Phillips screwdriver and eight flat-head screws attach the
overlay hooks to the back of the overlay frame. See "Overlay
Frame-Rear View" for overlay hook locations.
A. Overlay hooks (4)
Door Hinge Holes
•
The views of the top and bottom hinge pin hole show a right-
hand hinge. Mirror the image for a left-hand hinge.
•
We recommend
using a C-Clamp and two pieces of scrap
wood (front and back) to help reinforce the overlay frame
when drilling the hinge pin holes.
Using a V_" Brad point doweling drill bit, drill a _/_"(1.27 cm)
deep hole into the top of the overlay frame for the top hinge
pin as shown.
Top View
Front Surface
Back Surface
A. Radius 5.0
Publicité
