Calculated Industries SCALE MASTER CLASSIC 6020 Guide De L'utilisateur page 4

1.800.561.8187
[MODE] – Mode Selection
Used to toggle between the following scale
modes (in sequence):
ARCH
1) Architectural ( )
ENG I
2) Engineering I ( )
ENG II
3) Engineering II ( )
CUSTOM
4) Custom ( )
COUNT
5) Count ( )
[SUBTRACT/COUNT]+[MODE] –
Unit Selection
[SUBTRACT/COUNT]
Holding
[MODE]
repeated presses of will scroll
through the available units. Values can be
converted from U.S. units to Metric within
the U.S. mode. However, values cannot
be converted from Metric to U.S. when in
Metric mode.
[SCALE] – Scale Selection
Used to toggle between various scales within
each scale mode. See "Built-In Scales" section.
[M1+] – Memory Add Key (Length)
Adds the displayed value to the M1+
memory. This key is used to store a length in
order to calculate an area.
[M2x] – Memory Add Key (Width)
Adds the displayed value to the M2x memory.
This key is used to store a width in order to
calculate an area. When a length and width have
[M1+] [M2x]
been stored in and
[RCL] [M2x]
displays the stored width, the
[M2x]
next press of displays the area calculated
from the stored length and width, and the next
[M2x]
press of displays the calculated volume if
a height has been stored. Please see page 12 for
calculating an Area and Volume.
2 – Scale Master Classic
®
www. .com
and
, pressing
information@itm.com