Calculated Industries SCALE MASTER CLASSIC 6020 Guide De L'utilisateur page 11

1.800.561.8187
Programming Mode
The Scale Master Classic allows you to preset
frequently used values, including:
Height value
The following keys are used in programming mode:
[M1+]
Increases the selected digit/units.
[SUBTRACT/COUNT]
Decreases the
selected digit/units.
[SCALE]
Advances the cursor to the next
place to the right. Exits and saves changes if
pressed while right-most digit is selected.
[MODE]
Moves the cursor back to the next
place to the left.
[RESET]
Exits without saving.
Setting Custom Scales
You can program and store six Custom Scales:
three in U.S. mode and three in Metric mode.
You can set a custom scale two ways: by "rolling in"
a known distance or by entering the exact distance.
Rolling a Custom Scale
[MODE] #
1) Press until OPEN (# being a
number 1-3) appears in the scale box display.
[SUBTRACT/COUNT]
2) Press
" " will appear in the main display.
ROLL
3) Roll desired distance. "
ROLLING
appears in the main display.
Note: For greater accuracy, roll the longest known
distance you have on your plan.
[SCALE]
4) Press . The annunciator will begin
www. .com
[SCALE]
+ .
" now
(Cont'd)
9 – User's Guide
information@itm.com