HOW TO ORDER REPAIR PARTS
For Parts Assistance Call: 800-750-2723 Ext 5051 or Email: parts@usstove.com
The information in this owner's manual is specific to your unit. When ordering replacement parts the information
in this manual will help to ensure the correct items are ordered. Before contacting customer service write down the
model number and the serial number of this unit. That information can be found on the certification label attached
to the back of the unit. Other information that may be needed would be the part number and part description of the
item(s) in question. Part numbers and descriptions can be found in the "Repair Parts" section of this manual. Once
this information has been gathered you can contact customer service by phone 1-800-750-2723 Ext 5051 or Email
parts@usstove.com.
INSTRUCTIONS SPECIFIC FOR CANADIAN
Do not obstruct the space under the heater and do not obstruct the combustion air openings.
Refer to the chimney manufacturer's instructions for disassembling the chimney/venting for transportation of a
transportable building.
The parts or materials to be employed for ember protectors and the minimum areas to be covered and their relation
to the space heater, as well as the notice: "In Canada, to comply with CSA B365, Installation Code for Solid-Fuel-
Burning Appliances and Equipment, any combustible covering beneath the appliance and/or within the area extending
horizontally at least 450 mm (18 in) beyond the appliance on any side equipped with a door, and at least 200 mm (8 in)
beyond the appliance on other sides, shall be protected by a continuous, durable, non-combustible pad that will provide
ember protection. The 450 mm (18 in) ember protection required on any side with a door shall extend for the full width
of the appliance plus the 200 mm (8 in) required on each side of the appliance without a door. Where an appliance is
installed less than 200 mm (8 in) from a wall, the ember pad need only extend to the base of the wall. An ember pad
shall not be placed on top of a carpet unless the pad is structurally supported to prevent displacement and distortion.
If this appliance is installed in a transportable building, removal of the chimney/venting is required for transportation
of the building.
DO NOT INSTALL IN AN ALCOVE
DO NOT INSTALL IN ANY FIREPLACE
Model Information
Model Number
Serial Number
INSTALLATIONS
17
© 2023 United States Stove Company