Publicité
All manuals and user guides at all-guides.com
- Green LED is on: indicates that charging process is completed.
7. At the end of charging time:
- Unplug the charger from the mains and disconnect the battery.
- Store the charger
- Replace the battery in the compartment (Fig.8b)
- Close the battery cover (Fig.8a)
Fig.8a
Fig.8b
Fig.8c
6.3- Blade
6.3.1- Blade assembly and/or replacement
Warning! Switch off the security switch before proceeding to any inervention.
Wear protective gloves.
Warning! Do not use a worn out, broken, cracked or damaged blade.
Use only an original blade or a blade recommended by the manufacturer
a) A worn out blade may lead to poor performance and
motor overload.
Before each operation, check the condition of the blade.
Sharpen or replace blade if necessary.
It is recommended to perform the replacement by qualified
specialist.
b) To remove the blade from its axis (Fig. 9)
- Block the blade (eg. using a wedge)
Fig.9
- Remove the bolt and nut.
- Remove the blade from the axis
- Install or assemble a blade, and then proceed with above
steps in reverse.
6.3.2- Sharpening the blade
Remove blade by following steps "b" in 6.3.1
Sharpen the blade with sharpener or mini-grinder.
Once blade is sharpened, re-assemble it on its axis.
Make sure that blade is tightened properly, to avoid a danger
6.3.3- Blade Lubrication
At the end of the season, before storing lawnmower for winter or before any extended period of non
use, clean and lubricate the blade and its shaft.
6.4- Cleansing
- Clean plastic parts with a soft and clean cloth
- Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
- Do not use any caustic to clean the plastic parts.
- Do not put or immerse tool in water or any other liquid.
a) Clean the plastic parts with a soft cloth and clean.
Do not use aggressive cleaning agents (solvents, abrasive cleansers) or an abrasive sponge or any
sharp objects.
- Do not use any caustic chemicals to clean the plastics parts.
- Never put or immerse the mower in water or any liquid, and ensure that water does not penetrate
Publicité
