Publicité
check the unit with its blades stopped. Continue your work only if the machine was not damaged.
- When working on slopes always stand diagonally to the slope, through a strong and stable position.
Always stands across the slope, never up or down directly. Be especially careful when you change
direction.
Do not work on very steep slopes.
- When you go to areas without grass (e.g. to change the workplace, over a driveway, ...), make sure
the blades are stopped.
- To avoid tripping, use extreme caution when reversing or when pulling the lawnmower towards
you.
- Protect the battery from heat (eg. do not leave the battery under direct sunlight ...), fire, water (eg. do
not store in damp places, do not leave it outside when raining ...)
- Overload protection: In case of overload or blocking, the fuse will operate and shuts down
automatically.
Turn off the motor and switch off the safety switch
Overload may be due to: a cutting height too low (re-adjust if necessary); at a cutting speed too fast
(reduce your speed).
The blockage may be due to the presence of debris on the blade (clean blade) or objects in the work
area (eg remove the branches or other objects ...)
Be sure to change the fuse with a fuse of the same technical data (fuse: AC 250V, 12A)
- Never pick up or carry an appliance while the motor is running.
- If the battery is running out of power, it should be charged accordingly. The battery can only be
charged using the correct charger (provided with the lawnmower).
Incorrect use may result in electric shock, overheating or leakage of corrosive liquid from the battery.
5.4- Working speed
The working speed may vary depending on the geography of the working area (e.g. flat ground,
hilly...), depending on the grass properties (e.g.: thickness, length, humidity ...) and the selected
cutting height.
It is important to maintain a working speed that allows full control of the mower at all times.
VI. MAINTENANCE AND STORAGE
Before any intervention on the product, make sure that the mower is switched off and switch
off the safety switch.
Any operation, maintenance, adjustment must be carried out with the machine at a standstill.
6.1- Maintenance and Cleaning
a) Have your tool serviced by a qualified person using only identical replacement parts.
This will ensure that the safety of your tool is maintained.
b) Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorised service centre is recommended.
c) Maintain tool with care.
Keep tool clean for better and safer performance.
6.1.1- Before each use
- Check the mower for any signs of damage or ageing.
- Check cutting blade condition, do not use it if worn out or cracked.
- Check battery charge level, and recharge if necessary.
- Make sure all screws and nuts are tight.
- If the mower shows any defect, return the device to a certified service center for repair if necessary.
6.1.2- After each use
- Same as 6.1.1
- Clean the mower of all debris and dirt.
- Store mower (see 6.6)
All manuals and user guides at all-guides.com
Publicité
