Publicité
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning: The vibration emission during actual use of the power tool can differ from the declared
total value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running idle in addition to the trigger time).
9.2. Fire hazard
a. Never charge batteries near acids or flammable materials.
b. Charge battery only at ambient temperatures between 0ºC and 45ºC.
After heavy use, allow battery to cool down before charging it.
9.3. Risk of explosion
a. Protect the battery against heat and fire!
b. Do not place the battery on radiators. Avoid prolonged direct exposure to sunlight.
c. Use battery only at ambient temperatures between 0ºC et 45ºC.
9.4. Risk of short circuit
a. For disposal, transport or storage, pack the battery in a plastic bag or a cardboard box, or isolate
the contacts with adhesive tape.
b. Do no open the battery pack.
9.5. WARNING! This machine produces an electromagnetic field during operation.
This field may under some circumstances interfere with active or passive medical implants.
To reduce the risk of serious or fatal injury, we recommend persons with medical implants to consult
their physician and the medical implant manufacturer before operating this machine.
9.6. WARNING! A certain level of noise emitted from this machine is not avoidable.
Plan noisy works according to local laws and at specific times.
Keep rest periods and if necessary restrict the working hours to a minimum.
For your own personal protection and the protection of bystanders have suitable hearing protection
worn.
10. Before you begin:
- The machine must be properly assembled before use.
- The machine should be carefully checked before each use. You should only work with a machine
that is in good condition. If you notice a fault on the machine that may cause danger to the operator or
the environment, do not operate the unit until the default has been repaired.
10.1. Browse the mowing area to:
- remove all objects and foreign materials that may be thrown by the moving blade,
- identify hard objects or risk areas to avoid damaging the lawnmower
10.2. Check the blades' condition, the safety features and cutting device conditions. Replace or repair
any defective part.
10.3. Remove all people or animals of the area.
11. Work only in daylight or under sufficient artificial light.
12. Proper use:
The user is solely responsible of others when working with the machine.
- Persons not familiar with the instructions, children, minors who have not yet reached the minimum
age to use the machine, and persons under the influence of alcohol, drugs or medications are not
allowed to operate the machine.
- Make sure that all safety devices (if any) are well assembled and in good condition.
- For a safe operation, do not operate the machine on steep slopes. Whenever using the machine on a
slope, slow down and ensure that you have proper balance.
- Hold the handle tightly, with both hands. Never use the machine only with one hand.
- Proceed walking with the lawnmower, never running. Guide the machine at slow speed. Do not
adopt abnormal positions. At all times. Maintain a proper balance.
13. Pay particular attention:
- When working on slopes. Never work in areas too steep.
- Pulling the lawnmower towards you
14. Make sure the blades stop running when:
- You tilt the lawnmower to move it over an area without grass.
- You transport the lawnmower.
All manuals and user guides at all-guides.com
Publicité
