Publicité
NOTE:
1. The battery compartment is located on the back end of the remote.
2. Press and slide the battery door open and remove the old battery.
3. Insert a CR2025 battery, checking that the "+" and "-" terminals of the battery
matches the inside of the battery compartment.
4. Replace the battery compartment door.
DO NOT mix old and new batteries.
DO NOT use rechargeable silver oxide cell batteries with remote control unit.
DO NOT mix alkaline. Standard (Carbon-zine). Or rechargeable (Nickle - Cadmium)
batteries.
DO NOT dispose of batteries in fire. Improper disposal may cause batteries to leak or
explode.
3. Operations of the device
3.1 Turn on
Plug in and switch on the heater with the power button on the side of the device. After
"BI" voice the heater will go into standby mode and show the
Press the
button to turn on the heater and the display shows the room
temperature.
3.2 Temperature setting
A. Temperature setting range is 5~50°C.
B. Default temperature setting is 15°C.
C. Press
flash and the temperature will increase or decrease by 1°C after each pressing
and save in 3 seconds if no action. The display will show the room
temperature after setting.
D. If the room temperature is 1°C higher than setting the temperature, it will stop
heating; if room temperature is 2°C lower than setting the temperature, it will
start heating.
or
button to set the temperature. The
icon on the display.
icon will
33
Publicité
