Publicité
● In order to decrease the danger of serious or fatal
injuries, it is recommended that individuals who wear
medical implants should consult their doctor and the
manufacturer of the implant before operating the
machine.
3
Operation
3.1
To attach and remove a battery
Caution! Make sure that the battery is correctly
attached. If the battery become loose, it can cause
personal injury.
Caution! Do not force the battery in place. If it is
not easy to attach, it is not correctly aligned.
3.1.1 To attach a battery
1
Align the battery to the slots in the casing.
2
Push the battery until it clicks into place.
3.1.2 To remove a battery
1
Push the button on the front of the battery.
2
Pull the battery out from the battery port.
3.2 Rotation selector
● Always do a check of the rotation before each use.
● Wait until all moving parts have completely stopped
before you change the direction of the rotation.
● Changing the rotation before it stops can damage the
drill driver.
● Always put the rotation selector button in neutral
position (middle position) when the product is not in
use.
1
Refer to the arrows on the rotation selector button.
2
Push the button to the left or right for clockwise or
counter-clockwise rotation.
3
Push the button so that it is positioned in the
middle for "NEUTRAL" or "LOCKED" position.
3.3 To attach an accessorie
1
Push the rotation selector button to turn the
rotation of the chuck counter-clockwise.
2
Put the accessorie on the anvil and push it in until
it locks in position.
3.4 To operate the product
Note! The work light goes on when the trigger is pushed.
The light turns off after you release the trigger.
1
Push the trigger to start the operation.
Note! The rotation speed of the chuck increases the more
the trigger is pushed.
2
Release the trigger to stop the operation.
4
Storage
● If the product is not going to be used for a long period
of time, keep the product in a clean and dry area,
where children and pets do not have access to it.
● Keep the product in a dry area, protected from direct
sunlight and wet conditions.
5
Maintenance
Caution! Stop the product and disconnect the
power supply before you do maintenance.
Caution! To prevent damage to the surface of
the product, do not use harsh detergents or abrasive
cleaners.
● Clean the product with a dry cloth if necessary.
● Use compressed air or a brush to clean hard to get to
areas.
6
Discard
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
7
Servicing
Warning! Only approved personnel must do
repairs on the product.
● The power tool must only be serviced by qualified
personnel using identical spare parts. This will ensure
that the power tool remains safe to use.
EN
SV
NO
PL
DE
FI
FR
NL
7
Publicité
