Publicité
TOOL PARTS
1 Main tool
2 Disassembly thrust piece
3 Disassembly thrust piece
4 Mounting thrust piece
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
SAFETY INFORMATIONS
Keep children and other persons away from the working area.
•
•
Do not allow children to play with this tool or its packaging.
Do not use the tool if parts are missing or damaged.
•
•
Use the tool for the intended purpose only.
•
Lifting of vehicles only allowed on the special lifting points.
Before starting work under a car always ensure that it is adequately supported by axle stands
•
or ramps. Chock wheels and ensure that the hand brake is firmly applied.
•
Always use approved eye protection, especially when working under vehicles.
Ensure a secure and well-gripped stance during fitting.
•
•
Ensure that tools are correctly mounted.
Regularly check the condition of the tool and replace the damaged parts.
•
Do not over tighten or use undue force as this can cause damage to both tool and component.
•
•
The tool is not suitable for air impact wrenches. The use of an air impact wrench may lead to
the spindle bearing or other components bursting and fragments of components flying around
may lead to injuries.
Always use workshop manual for detailed instructions.
•
•
Always lubricate the screw threads before using the tool.
Check & replace any damaged components as required.
•
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Trailing Arm Silent Block Tool Set
for Ford / Mazda / Volvo
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
5 Mounting thrust piece
6 Spindle
7 Upper tool bridge
8 Lower tool bridge with holding magnets
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 9444
Publicité
