Publicité
ENGLISH
6. Shoe
7. Saw blade
8. Saw blade guard
9. Riving knife
10. Saw dust outlet
Assembly
Warning! Before attempting any of the following
operations, make sure that the tool is switched
off and unplugged and that the saw blade has
stopped.
Removing and fitting a saw
blade (fig. A)
Removing
•
Keep the spindle lock button (5) depressed
and rotate the blade until the spindle lock
engages.
•
Loosen and remove the blade retaining
screw (11) by turning it counterclockwise
using the spanner (12) supplied.
•
Remove the outer washer (13).
•
Remove the saw blade (7).
Fitting
•
Place the saw blade onto the inner flange
(14), making sure that the arrow on the blade
points in the same direction as the arrow on
the tool.
•
Fit the outer washer (13) on the spindle, with
the raised part pointing away from the saw
blade.
•
Insert the blade retaining screw (11) into the
hole.
•
Keep the spindle lock button (5) depressed.
10
All manuals and user guides at all-guides.com
•
•
Adjusting the riving knife (fig. B)
The riving knife prevents the saw blade from
jamming during rip sawing operations. The riving
knife must be adjusted after replacing the saw
blade.
•
•
•
•
•
Fitting and removing the parallel
fence (fig. C)
•
Fitting
•
•
•
•
Removing
•
•
Securely tighten the blade retaining screw by
turning it clockwise using the spanner (12)
supplied.
Adjust the riving knife as described below.
Loosen the screws (15), using the spanner
(12), while holding the riving knife in position.
Position the riving knife (9) as shown.
The distance between the toothed rim and the
riving knife should be 2 - 3 mm.
The height difference between the toothed
rim and the lower end of the riving knife
should be 2 - 3 mm.
Tighten the screws.
The parallel fence is used to saw in a straight
line parellel to the edge of the workpiece.
Loosen the locking knob (16).
Insert the parallel fence (17) through the
openings (18).
Slide the parallel fence into the desired
position.
Tighten the locking knob.
Loosen the locking knob.
Pull the parallel fence off the tool.
Publicité
