ECOVACS WINBOT W2 PRO OMNI Manuel D'instructions page 21

3. Power Off
Press and hold on the Station for 2 seconds and more to power
WINBOT off.
4. Unfasten the Safety Rope
5. Charge the Station
Place the Station near a power outlet and connect it to the power
source. The charging time is approximately 3 hours at room
temperature.
6. Store the Station
Station should be stored in a dry environment to prevent moisture
affecting the battery and motherboard.
Notes:
1. Charging speed may slow down in low temperatures.
2. WINBOT and its Station are suitable for use in temperatures
ranging from 0° C to 40° C. Do not charge the Station in temperatures
outside this range.
3. The WINBOT fan cannot operate while charging. Please wait until
the charging is complete before using the WINBOT.
4. WINBOT's fan cannot operate while charging. Please use WINBOT
after charging is completed.
5. If you do not use WINBOT for an extended period, it is
recommended to periodically charge the Station to help maintain its
battery health.
6. If the Station is charging while WINBOT is working, the Station's
charging speed will be significantly slower compared to when
WINBOT is idle. At room temperature (10-40 ℃ ), this results in an
estimated charging time of more than 6 hours.
21 EN