JUKI MS-1261/V045 Manuel D'utilisation page 20

A
A: V045, V046 In the case of the steel roller → 0.01 to 0.1 mm
V045, V046 In the case of the urethane roller
→ No clearance should be provided between
the roller and the throat plate.
(Caution) In the case urethane roller is used, set the
roller pressure to a lower value than the
set value for the steel roller. In the case of
an excessively high presser foot pressure,
the cloth puller may deform or an abnormal
load may be applied to the device.
1)
Loosen nut 1 . Adjust the clearance by turning
adjusting screw 2 .
In the case the steel roller is used:
Adjust the clearance provided between the roller and
the throat plate (bottom roller) to 0.01 to 0.1 mm.
In the case the urethane roller is used:
Adjust the clearance provided between the roller and
the throat plate (bottom roller) to 0 mm so that no
clearance is provided between them.
(V045)
– 10 –