Publicité
PROGRAMMING MODE
You can program the heater every day with 2 time settings per day.
Press and hold the power button again for more than 1.5 seconds to go into
the 1-7 program setting mode. Please follow the above steps for programming
5+2 to be able to set the time slots.
Hints
•
In each mode running mode, you can reset the current running mode
parameters by pressing and holding the button ▲ for more than 1.5
seconds.
•
In weekly timing mode, OFF indicates that the weekly timing period is not
on.
When the weekly timing period come on, press button ▲ or ▼ to change
•
the setting temperature of the current period.
•
Whether it's 5+2 mode or 1-7 mode,the default starting time of first group
is 18:00, the ending time is 08:00, and the default operating temperature
is 20.0 °C.
•
The running time of Programs 1/2/3/4 should not be overlapped, and the
ending time value of each program must be later than the starting time,
otherwise setting is invalid.
•
The start time and end time must be set at the same time to take effect. If
only the start time or end time is set,the program will not work.
CLEANING AND CARE
WARNING
Risk of electric shock
Do not open the cover. There are no customer serviceable
parts inside.
•
Ensure that the power supply to the device is disconnected before any
installation or maintenance.
•
Clean the device with a soft, non-abrasive, damp cloth while warm.
•
Once the device has cooled, lightly polish with a soft, dry cloth.
•
Do not use abrasive cleaning powders, metal polish, or chlorine based
cleaners on any part of the device.
EN
27
Publicité
