Publicité
EN
20
INSTALLATION
This appliance must be installed in accordance with the instructions in the
manual and the IEC guidelines relating to electrical fixtures in bathrooms. The
device must be on a GFCI-protected circuit and be wired by a professional who
is certified to do electrical wiring.
1. Screw the screw "I" through the baffle "H" into the reserved hole on the
top of the device as show in the diagram below.
2. Choose the mounting position, keep the required minimum distances.
3. Affix the mounting template to the wall, determine the drilling position,
and proceed to drill using an 8mm rotary drill bit.
Note: Excessive drilling diameter is strictly prohibited !
Publicité
