Publicité
LED indicator A①
• When ZONE 1 relay is activated, the door indica-
tor will turn green.
• When ZONE 2 relay is activated, the door indi-
cator will turn red.
If you forget the admin code, press but-
ton
and hold it down, then power on.
The beep indicates that the preset admin code has
been reset.
Modifying the administrator code
After going into programming:
Press buttons
and . The LED indicator will flash
yellow. Enter a new admin code twice (the length
of the new admin code must be the same as the old
one) and a long beep sounds to indicate that the
modification has been successful.
Press button
to exit programming mode.
The pick-proof alarm
If the device is tampered with, the built-in bell will
ring continuously. The bell will stop when tampering
is no longer detected, or if you enter the admin code,
and in any event automatically after 60 seconds.
Turning the pick-proof alarm on and off
After going into programming:
Press buttons
and . The LED indicator will flash
yellow. Press buttons and . A long beep sounds
and the LED indicator stays on yellow.
The pick-proof alarm is turned off.
Press buttons
and . The LED indicator will flash
yellow. Press buttons and . A long beep sounds
and the LED indicator stays on yellow.
The pick-proof alarm is turned on.
Press button
to exit programming mode.
Turning the door bell on and off
After going into programming:
Press buttons
and , (the LED indicator flashes
yellow), followed by
and the LED indicator is yellow. The door bell func-
tion is turned off.
and . A long beep sounds
Press buttons
and
yellow), followed by
and the LED indicator is yellow. The door bell func-
tion is turned on.
Press button
to exit programming mode.
To trigger the door bell, press button
the device is in standby mode.
Attention: Triggering the door bell deactivates
the door release function via the Zone 2 relay.
Adding a master card (only for ZONE 1)
After going into programming:
Press buttons
and
indicates that no master card has been stored.
The green LED indicates that a card has already
been stored.
In this event, press button
data. The LED flashes green. Swipe the master card;
a long beep sounds to indicate that the card has been
added correctly.
Press button
to exit programming mode.
Going into programming via the master card
Swipe the master card. The LED indicator will turn
yellow and a long beep will sound.
To exit the setting mode:
Swipe the master card again; three fast beeps sound
to confirm this.
If the wrong admin code is repeatedly
entered or a card that is not validated is swiped
5 times, the access control is blocked for 60
seconds.
Door status detection (only for ZONE 1): When
someone opens the door and goes in and the
door is closed, the system automatically detects
the status of the door and locks it even if the
unlock delay is still in progress.
The code for ZONE 1 must be different from
that of ZONE 2.
, (the LED indicator flashes
and . A long beep sounds
when
. The flashing green LED
twice to clear the
7
Publicité
