Publicité
Adding a user card and code (ZONE 2)
After going into programming:
1. Press buttons
and . The LED indicator will
flash yellow. Enter two digits from 00 to 09 to
identify the data storage unit; a yellow LED
indicator will flash.
2. If the LED indicator is red, it means that data
is already stored in the unit. Press button
twice to clean up and start again from point 1.
3. If the LED indicator is green, it means that
access cards and codes can be added to the
data storage unit.
Steps for adding cards or passwords:
4. Swipe the card; the sound indicates that it has
been added. Key in the relative access code. The
length of the access code should be the same as
the admin code. For example, if the admin code
is 12, you can set 00-99 as your password. The
sound indicates that the access card and code
have been added correctly.
Press button
to exit programming mode.
Deleting a user card or code (ZONE 2)
After going into programming:
Press buttons
and . The LED indicator will flash
yellow. Enter two-digits from 00 to 09 to identify the
data storage unit. If the LED indicator is red, it means
that data is already stored in the unit. Press button
twice to delete the card and the code.
Setting the unlocking delay for ZONE 1
After going into programming:
Press buttons
and . The LED indicator will flash
yellow. Enter two digits from 00 to 99 corresponding
to the desired delay (05 means that the unlocking
time is delayed for 5 seconds). The LED indicator
stops flashing and a beep sounds to indicate the
delay has been set correctly.
If the delay is set at 00, swipe the card or enter the
access code once to open the door, swipe the card
or enter the access code again to close the door.
Press button
to exit programming mode.
6
Setting the unlocking delay for ZONE 2
After going into programming:
Press buttons
and . The LED indicator will flash
yellow. Enter two digits from 00 to 99 corresponding
to the desired delay (05 means that the unlocking
time is delayed for 5 seconds). The LED indicator
stops flashing and a beep sounds to indicate the
delay has been set correctly.
The default delay is 1 second; if the delay is set at
00 swipe the card or enter the access code once to
open the door, swipe the card or enter the access
code again to close the door.
Press button
to exit programming mode.
Clearing all the user cards and codes
After going into programming:
Press buttons
and
flash yellow. Press button
indicator turns yellow and a long beep sounds to
indicate that all the user cards or codes have been
cleared correctly.
Press button
to exit the programming mode and
go to stand by.
Restoring factory settings
Press buttons
and . The LED indicator will flash
yellow. Press button
turns yellow and a long beep sounds to indicate that
all the factory settings have been restored.
Note: the password reverts to the default "1234".
Press button
to exit the programming mode and
go to stand by.
If the information entered is correct, there's
a double beep.
If no operation is carried out within 30 seconds
the device resets automatically and a double
beep sounds.
If the device isn't in programming mode and
you enter an incomplete password or try to open
the door with the wrong operations, the device
automatically resets and a double beep sounds.
. The LED indicator will
twice. The LED
twice. The LED indicator
Publicité
