Publicité
Technical Data
Max. operating pressure
Material inlet thread size
Diffuser thread size
Wetted parts material
Operating temperature range
Maximum material temperature
Maximum sound output
Weight
* Measurement location: 0.5 m away from the coating surface, 0.5 m behind the spray gun,
spray pressure 12 MPa, tip size 0.021
Introduction
This airless spray gun is to be used for the
high pressure atomization of liquid coating
materials.
Using the Gun Trigger Lock
Always engage the gun's trigger lock when the
gun is not in use.
1. To lock the trigger, rotate the trigger lock
forward until it stops.
2. To unlock the trigger, rotate the trigger
lock backward until it is vertical.
1
Gun locked
(gun will not
spray)
Setup
Never attempt to assemble,
change, or clean the gun, tip, or
tip guard without first relieving
pressure from the spray system.
Follow the "Pressure Relief
Procedure" in the sprayer's
Owner's Manual.
Always use a tip safety guard
for added protection against
injection. Beware that the guard
alone will not prevent injection.
Never cut off tip guard! Always
engage gun trigger lock when the
gun is not in use. Before servicing
equipment, consult Owner's
Manuals and follow all warnings.
14
GB
25 MPa (3600 PSI)
M16 x 1.5 (NPSM 1/4")
7/8 - 14 UN-2A (G)
High-grade steel, aluminum, PTFE, hard metal
5ºC to 40ºC (40ºF to 104ºF)
43ºC (109ºF)
81 dB(A)*
120 cm = 1.8 kg (4 lb)
2
Gun unlocked
(gun will
spray)
1. Set up the sprayer. Refer to the
instructions in the sprayer's Owner's
Manual.
2. Attach a grounded, airless spray hose to
the material inlet on the gun. Using two
wrenches (one on the gun and one on
the hose), tighten securely.
3. With the tip, tip swivel, and tip guard
off the gun, start the sprayer. Flush and
prepare the spray system according to
the sprayer's Owner's Manual. Inspect
the spray system to make sure that all
fittings are secure and that there are no
leaks.
4. Perform the "Pressure Relief Procedure"
described in the sprayer's Owner's
Manual.
5. Place the seal washer and pole mount
over the diffuser, and secure in position
using the retaining nut. Tighten securely
using a wrench.
6. Thread the tip swivel onto the pole
mount. Tighten securely using a wrench.
7. Insert the tip into the slot on the tip
guard. Thread the tip guard onto the tip
swivel. Tighten securely using a wrench.
Seal Washer
Tip seal
Tip
retainer
Tip seal
Tip Guard
i
The arrow on the tip handle
should be pointing in the forward
direction for spraying.
11/16 - 16 UN-2A (F)
200 cm = 3.2 kg (7 lb)
Extension Pole
Di user
Pole Mount
Retaining Nut
Tip Swivel
Pole Gun
Publicité
