Publicité
In order to prevent work related illness, the manufacturer's regulations for the materials,
solvents, and cleaning agents used must be observed when preparing, working with and
cleaning the unit. Protective clothing, gloves, eyewear, and, in certain cases, protective skin
cream are necessary to protect the skin.
• Follow the coating material and solvent manufacturer's warnings and instructions.
• Extraction equipment should be installed by the user in accordance with local regulations.
• The objects being sprayed must be earthed.
• Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover. Check
for damage or movement of couplings. Immediately replace the hose if any of these
conditions exist. Never repair a paint hose. Replace it with another grounded high-
pressure hose.
• Pulling the trigger causes a recoil force to the hand that is holding the spray gun.
The recoil force of the spray gun is particularly powerful when the tip has been removed
and a high pressure has been set on the airless high-pressure pump. Therefore, when
cleaning without tip set the pressure control valve to the lowest pressure.
• Use only manufacturer authorized parts. User assumes all risks and liabilities when using
parts that do not meet the minimum specifications and safety devices of the spray gun
manufacturer.
EXPLOSION PROTECTION IDENTIFICATION
X marking:
The spray gun corresponds with Ex II 2G X and is, in accordance with Directive 94/9/EEC
(Atex 100a), suitable for use in explosion-hazardous areas—as of type Zone 1. Under
certain circumstances, the unit itself may cause the Zone 1 condition to be in effect.
Any static-electricity discharge from the spray gun is to be diverted to the grounded high-
pressure pump via the conductive high-pressure hose as stipulated.
The maximum surface temperature corresponds to the permissible material temperature.
This and the permissible ambient temperature can be found in the Technical Data.
To avoid the generation of machine sparks, prevent impact stresses and any work on the unit
with tools in the explosion-hazardous area.
Residual risks
Residual risks are risks, which cannot be excluded, even when equipment is used for the
intended purpose.
In such cases the applicable areas of the actual residual risks will be pointed out using warning
and/or prohibition signs.
Risk
Source / Cause
Injection
Atomized, high
injury
pressure stream of
fluid
Explosion or
Static electricity or
fire
sparks
Hazardous
Hazardous vapors
vapors
from spray material
Pole Gun
Impact
Preventative measures
Severe
NEVER aim the gun at
injury or
any part of the body
amputation
Severe
Use well ventilated area
injury
Ground the spray gun
Severe
Use well ventilated area
injury
Use mask
Can occur
during:
Setup,
Operation
Operation
Operation
13
GB
Publicité
