Publicité
6.1.7.3 Test function menu
A diagnostic menu is available to conduct operational
tests on the device.
It allows you to configure the following parameters:
Enable the Wiper: Allows users to enable the
1.
wiper.
2.
Enable Night Mode: Enables night mode
activation in continuous mode (6.1.5.5
Advanced Configurations Menu (Infrared)).
3.
Enable the Relay: Allows users to enable the
relay.
4.
Device reboot: Allows users to reboot the
device.
5.
I/O status: Allows access to the l/O status menu.
TEST FUNCTIONS
------------------------
1>WIPER START
2>NIGHT MODE ON
3>RELAY ON
4 DEVICE REBOOT
5 I/O STATUS
Fig. 31
MNVCMVXCAM_1645_EN
6.1.7.3.1 I/O status menu
This menu displays the status of certain device
components (useful for diagnostic functions).
Input alarm: Displays the alarm status (enabled or
disabled).
Dip In: Displays the status of the control board dip-
switch.
Relay: Displays the relay status (enabled or disabled).
Wiper: Displays the wiper status (enabled or
disabled).
Camera Power Supply: Displays the camera status
(enabled or disabled).
I/O STATUS
------------------------
ENTRY ALARM
DIP IN
RELAY
: N
WIPER
: N
CAMERA POWER
: Y
: Y
>
Fig. 32
: 0
: 0
: 0
: 0
: 1
21
Publicité
