Publicité
CLEANING THE FILTER
See Figure 11.
NOTE: If chemical has recently been sprayed, use gloves
for this procedure.
„ Unscrew the tank from the quick connect.
„ Lift tabs on the side of the filter cap.
PROBLEM
Spray pattern is inconsistent.
Unit will not spray or sprays
improperly.
Unit is "spitting" after trigger is
released.
Spray is weak.
Unit runs for a short period
then shuts off.
Will not spray
This product has a Two-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
MAINTENANCE
TROUBLESHOOTING
POSSIBLE CAUSE
Unit is not level and is allow-
ing fluid to enter through the
tank filter.
Unit is being shaken or moved
too fast.
Fluid level is too low in the
tank.
Liquid in tank is too thick.
Filter or nozzle needs to be
cleaned.
Solution is too thick.
Battery needs charging.
Solution is too thick.
Need to release pressure
or call (toll free) 1-800-525-2579.
11 — English
„ Remove the seals and filter screen.
„ With a soft brush and soapy water, clean debris from the
filter screen.
„ Reinstall seals and screen.
„ Press the filter cap on until the tabs securely fit back in
place.
SOLUTION
Unit must be kept level during use.
Allow the unit to remain still until the liquid inside settles
and normal spraying/fogging resumes, then move slowly
and do not shake the unit during use.
Replenish the tank to a higher volume.
Empty the tank, clean both the tank and filter, then try
again. Make sure that all chemicals/liquid used in the
sprayer are as thin as water.
Clean filter as described in Cleaning the Filter.
Make sure that all chemicals/liquid used in the sprayer
are as thin as water.
Recharge the battery.
Make sure that all chemicals/liquid used in the sprayer
are as thin as water.
Run on the stream setting for at least 60 seconds
Publicité
