Publicité
WARNING:
Improper mixing, combining or application of spray prod-
ucts or solutions can result in SEVERE INJURY or DEATH.
Follow all CDC and EPA guidelines. Follow the chemical
manufacturers instructions printed on their product label-
ing, SDS sheet and/or EPA Master Label.
WARNING:
Do not allow conductive or corrosive fluids to get inside
the battery pack. If conductive or corrosive fluids are
spilled on the battery, refer to the instructions in your
battery operators manual.
NOTICE:
Disconnect tank and fill away from sprayer. Clean the
exterior of the tank and clean up any spillage before
reconnecting tank.
When adding spray solutions, you may add water and the
desired chemical solution directly into the tank, or use a
solution that has been premixed in a separate container,
then poured into the sprayer, using a funnel if needed. For
either method, remember:
„ Liquids used must be as thin as water. Thicker liquids will
not spray properly.
„ Do not overfill the tank.
NOTE: If using a measuring container or funnel to fill the
tank, be sure to thoroughly clean and rinse these items after
use. If premixing the chemical solution, rinse the container
used for mixing.
To fill the tank:
„ Remove the battery pack.
„ Unscrew the tank from the sprayer.
„ Fill the tank with the desired liquid, up to 0.5 L (16.9 oz.)
NOTE: To ensure proper operation of the sprayer, DO
NOT overfill the tank.
To reconnect the tank:
„ Wipe the outside of the tank with a dry cloth and clean
up any spills before reconnecting the tank.
„ Carefully screw the tank back onto the sprayer, making
sure it is tightened securely.
„ Reinstall the battery pack.
OPERATION
Fluid may escape from the quick connect if the tank is
not fully drained. Be cautious, and wear the appropriate
protective equipment as specified on the chemicals.
NOTICE:
It is important to thoroughly clean the unit after each use.
Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.
INSTALLING/REMOVING BATTERY PACK
See Figure 4.
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
„ Unscrew and remove the battery cap.
„ Insert the battery pack into the product as shown.
„ Place the cap over the battery pack and push down until
the cap meets the threads at the end of the tool.
„ Screw the cap on securely.
NOTE: Do not attempt to use this product if the battery
cap is not securely closed.
To remove:
„ Unscrew and remove the battery cap.
„ Remove the battery pack from the tool.
For complete charging instructions, see the operator's manual
for your battery pack.
LED LIGHT FUNCTIONS
See Figure 4.
When a charged battery pack is installed in the tool, the
LED light will indicate the status of the tool when the tool
is powered on.
Exhausted Battery
8 — English
WARNING:
WARNING:
TOOL STATUS
Normal
Low Battery
LED LIGHT SCENARIO
Solid Green (No Flashes)
Solid Red (No Flashes)
Flashing Red (6 Flashes)
Publicité
