Publicité
Do not use adapters, multiple
connectors and/or extensions.
The plug should be accessible
for
disconnection
appliance has been installed.
Do not plug the machine in and
switch it on at the mains until
the installation is completed.
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
Ventilation
Adequate ventilation must be
provided in the room where the
tumble dryer is located to
prevent gases from appliances
burning other fuels, including
open fires, being drawn into
the room during operation of
the tumble dryer.
Install the rear of the appliance
close to a wall or vertical surface.
There should be a gap of at
least 12 mm between the
machine and any obstrubtions.
The inlet and outlet air should
be kept clear of obstruction.
Make sure carpets or rugs do
not obstruct the base or any of
the ventilation openings.
Prevent items from falling or
collecting behind the dryer as
these may obstruct the air inlet
and outlet.
after
the
Exhaust
discharged into a flue which is
used for exhausting fumes
from appliances burning gas or
other fuels.
Check regularly that the air
flowing around the dryer is not
restricted, avoiding accumulation
of dust and lint.
Check frequently the fluff filter
after use, and clean, if necessary.
The Laundry
Always refer to the laundry
care labels for directions on
suitability for drying.
Fabric softeners, or similar
products, should be used as
specified by the fabric softener
instructions.
Do not dry unwashed items in
the tumble dryer.
Clothes should be spin dried or
thoroughly wrung before they
are put into the tumble dryer.
Clothes that are dripping wet
should not be put into the dryer.
66
air
must
not
be
Publicité
