CTEK Barrett-Jackson 1065 Mode D'emploi page 8

OPERATING INSTRUCTIONS
1. Connect the charger to the battery.
2. Connect the charger to the wall socket. The power lamp will indicate that the mains cable is connected
to the wall socket. The error lamp will indicate if the battery clamps are incorrectly connected. The
reverse polarity protection will ensure that the battery or charger will not be damaged.
3. Press the MODE-button to select charging program.
4. Follow the 8-step display through the charging process.
The battery is ready to start the engine when STEP 4 is lit.
The battery is fully charged when STEP 7 is lit.
5. Stop charging at any time by disconnecting the mains cable from the wall socket.
MODE BUTTON
ERROR LAMP
MODE
POWER LAMP
SMALL
BATTERY
PROGRAM
READY TO USE FULLY CHARGED
RECOND
NORMAL
BATTERY
WEATHER
PROGRAM
PROGRAM
RECOND
PROGRAM
COLD
EN • 7