Publicité
2.3 Removing the transportation locks
Do not remove the transportation locks before taking out the
packaging reinforcement.
1. Loosen all the bolts with a suitable spanner until they rotate
freely (C).
2. Remove transportation safety bolts by turning them gently.
3. Attach the plastic covers supplied in the User Manual bag
into the holes on the rear panel. (P)
Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
Never move the product without the transportation safety bolts properly fixed in place!
2.4 Connecting water supply
The water supply pressure required to run the product is
between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
liters of water flowing from the fully open tap in one minute
to have your machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
Models with a single water inlet should not be connected to
the hot water tap. In such a case the laundry will get
damaged or the product will switch to protection mode and
will not operate.
Do not use old or used water inlet hoses on the new product.
It may cause stains on your laundry.
2.5 Connecting to the drain
Your house will be flooded if the hose comes out of its housing during water discharge. Moreover, there is risk of
scalding due to high washing temperatures! To prevent such situations and to ensure smooth water intake and discharge
of the machine, fix the end of the discharge hose tightly so that it cannot come out.
• The end of the drain hose must be directly connected to the
wastewater drain or to the wash basin.
• The hose should be attached to a height of at least 40 cm,
and 100 cm at most.
• In case the hose is elevated after laying it on the floor level or
close to the ground (less than 40 cm above the ground), water
discharge becomes more difficult and the laundry may come
excessively wet. Therefore, follow the heights described in
the figure.
www.linarie.com.au
Remove the transportation safety bolts before operating the
washing machine! Otherwise, the product will be damaged.
1. Tighten all hose nuts by hand. Never use a tool when tighte-
ning the nuts.
2. Open the taps completely after making the hose connection
to check for water leaks at the connection points. If any leaks
occur, turn off the tap and remove the nut. Retighten the nut
carefully after checking the seal. To prevent water leakages
and damages caused by them, keep the taps closed when the
machine is not in use.
• To prevent flowing of dirty water back into the machine and
to allow for easy discharge, do not immerse the hose end into
the dirty water or do not drive it in the drain more than
15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be
stepped on and the hose must not be pinched between the
drain and the machine.
• If the length of the hose is too short, use it by adding an
original extension hose. Length of the hose may not be
longer than 3.2 m. To avoid water leak failures, the connec-
tion between the extension hose and the drain hose of the
product must be fitted well with an appropriate clamp as
not to come off and leak.
5
Publicité
