Publicité
5.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please see
Operating the product - Programmes.
For products without drum cleaning, follow the below steps
to clean the drum:
Select Additional Water or Extra Rinse auxiliary functions.
Use a Cottons programme without pre-wash. Set the tem-
perature to the level recommended on the drum cleaning
agent which can be provided from authorized services.
Apply this procedure without any laundry in the product.
Before starting the programme, put 1 pouch of special
drum cleaning agent (if the special agent could not be
supplied, put max. 100 g of powder anti-limescale) into
the main wash detergent compartment (compartment
no. "2"). If the anti-limescale is in tablet form, put only
one tablet into the main wash compartment no. "2".
Dry the inside of the bellow with a clean piece of cloth
after the programme has come to an end.
Repeat Drum Cleaning process in every 2 months.
5.3 Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-
corrosive mild gel detergents as necessary, and dry with a
soft cloth. Use only a soft and damp cloth to clean the
control panel.
5.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at
the rear of the machine and also at the end of each
water intake hose where they are connected to the tap.
These filters prevent foreign substances and dirt in the
water to enter the washing machine. Filters should be
cleaned as they do get dirty.
www.linarie.com.au
Use an anti-limescale suitable for the
washing machines.
After every washing make sure that no foreign substance
is left in the drum.
If the holes on the bellow shown in the figure is blocked,
open the holes using a toothpick.
Foreign metal substances will cause rust stains in the
drum. Clean the stains on the drum surface by using
cleaning agents for stainless steel. Never use steel
wool or wire wool.
Never use sponge or scrub materials. These will damage
the painted and plastic surfaces.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access
the filters on the water intake valves. Clean them with
an appropriate brush. If the filters are too dirty, take
them out by means of pliers and clean them.
14
Publicité
