Publicité
1.3 Package information
Packaging materials of the product are manufactured from recyclable materials in accordance with our
National Environment Regulations. Do not dispose of the packaging materials together with the domestic or other wastes.
Take them to the packaging material collection points designated by the local authorities.
1.4 Disposing of the waste product
This product has been manufactured with high quality parts
and materials which can be reused and are suitable for
recycling. Therefore, do not dispose the product with normal
domestic waste at the end of its service life.
Take it to a collection point for the recycling of electrical and
electronic equipment.
1.5 Compliance with WEEE Directive
This product complies with EU WEEE Directive (2012/19/EU).
This productbears a classification symbol for waste electrical
and electronic equipment (WEEE).
This product has been manufactured with high quality parts
and materials which can be reused and are suitable for
recycling.
Do not dispose of the waste product with normal domestic
and other wastes at the end of its service life. Take it to the
collection center for the recycling of electrical and electronic
equipment. Please consult your local authorities to learn
about these collection centers.
2. INSTALLATION
Refer to the nearest Authorised Service Agent for installation
of the product. To make the product ready for use, review
the information in the user manual and make sure that the
electricity, tap water supply and water drainage systems are
appropriate before calling the Authorized Service Agent. If
they are not, call a qualified technician and plumber to have
any necessary arrangements carried out.
Preparation of the location and electrical, tap water
and waste water installations at the place of
installation is under customer's responsibility.
Make sure that the water inlet and discharge hoses as well as
the power cable are not folded, pinched or crushed while
pushing the product into its place after installation or cleaning
procedures.
2.1 Appropriate installation location
Place the machine on a rigid floor. Do not place it on a
long pile rug or similar surfaces.
Total weight of the washing machine and the dryer -with
full load- when they are placed on top of each other
reaches to approx. 180 kilograms. Place the product
on a solid and flat floor that has sufficient load carrying
capacity!
Do not place the product on the power cable.
Do not install the product at places where temperature
may fall below 0ºC.
Place the product at least 1 cm away from the edges of
other furniture.
www.linarie.com.au
Please consult your local authorities to learn the nearest
collection point. Help protect the environment and natural
resources by recycling used products. For children's safety,
cut the power cable and break the locking mechanism of the
loading door so that it will be non-functional before disposing
of the product.
Compliance with RoHS Directive:
The product you have purchased complies
with EU RoHS Directive (2011/65/EU).
It does not contain harmful and prohibited
materials specified in the Directive.
Installation and electrical connections of the product must be
carried out by the Authorized Service Agent. Manufacturer
shall not be held liable for damages that may arise from
procedures carried out by unauthorized persons.
Prior to installation, visually check if the product has any
defects on it. If so, do not have it installed.
Damaged products cause risks for your safety.
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement by
pulling the ribbon.
4
Publicité
