Publicité
Changing the selections after programme
has started
Switching the machine to pause mode
Press the Start / Pause button to switch the machine to pause
mode while a programme is running. The light of the step
which the machine is in starts flashing in the Programme
Follow-up indicator to show that the machine has been
switched to the pause mode.
Also, when the loading door is ready to be opened, procedure
step light is steady on, door lock light is off.
Changing the speed and temperature settings for
auxiliary functions
Depending on the step the programme has reached, you may
cancel or activate the auxiliary functions; see, "Auxiliary
function selection".
You may also change the speed and temperature settings;
see, "Spin speed selection" and "Temperature selection".
If no change is allowed, the indicator light will be on.
Adding or taking out laundry
Press the Start / Pause button to switch the machine to pause
mode. The programme follow-up light of the relevant step
during which the machine was switched into the pause mode
will flash. Wait until the Loading Door can be opened.
Open the Loading Door and add or take out the laundry.
Close the Loading Door. Make changes in auxiliary functions,
temperature and speed settings if necessary. Press Start /
Pause button to start the machine.
5. MAINTENANCE AND CLEANING
Service life of the product extends and frequently faced
problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 4-5
washing cycles) as shown below in order to prevent accu-
mulation of powder detergent in time.
1. Press the dotted point on the siphon in the softener
compartment and pull towards you until the compartment
is removed from the machine.
If more than normal amount of water and softener
mixture starts to gather in the softener compartment,
the siphon must be cleaned.
www.linarie.com.au
Canceling the programme
To cancel the programme, turn the Programme Selection
knob to select another programme. Previous programme
will be canceled. End / Cancel light will flash continuously t
o notify that the programme has been canceled.
Pump function is activated for 1-2 minutes regardless of the
programme step, and whether there is water in the machine
or not. After this period, your machine will be ready to start
with the first step of the new programme.
Depending on the step where the programme was
canceled in, you may have to put detergent and
softener again for the programme you have
selected anew.
End of programme
"End" appears on the display at the end of the programme.
Wait until the loading door light illuminates steadily.
Press On / Off button to switch off the machine.
Take out your laundry and close the loading door.
Your machine is ready for the next washing cycle.
2. Wash the detergent drawer and the siphon with plenty of
lukewarm water in a washbasin. Wear protective gloves or
use an appropriate brush to avoid touching of the residues
in the drawer with your skin when cleaning.
3. Insert the drawer back into its place after cleaning and
make sure that it is seated well.
If your detergent drawer is the one indicated in the
following figure:
Lift the rear part of the siphon to remove it as
illustrated. After performing the above mentioned
cleaning procedures, replace the siphon back to its
seating and push its front section downwards to
make sure that the locking tab engages.
13
Publicité
