Publicité
6.2 Speed control (Fig. 6)
The equipment is fi tted with an electronic speed
controller. To use it, turn the speed controller (Fig.
6/Item 6) to the desired position. Use the equip-
ment only with the speed which is actually requi-
red and never let it run at a speed which is faster
than necessary.
6.3 Turbo mode (Fig. 6)
If you need a higher blowing velocity for a short
time, you can press the TURBO button (Item 3c).
Pressing the TURBO button will increase the
speed for a short time, providing the maximum
blowing velocity.
Important: To minimize noise and maximize batte-
ry operating time, you should not press the TUR-
BO button any longer than necessary.
6.4 Blowing foliage
•
Turn on the equipment (see section 6.1).
•
Set the desired blowing velocity with the
speed controller (see section 6.2).
•
Direct the air stream forward and walk slowly
to blow foliage or garden refuse into a pile or
to remove it from hard-to-reach places.
•
To increase the blowing velocity for a short
time, use TURBO mode (see section 6.3).
Danger!
Never gather (blow) hot, combustible or explosive
materials into piles.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the mo-
tor housing free of dirt and dust as far as pos-
sible. Wipe the equipment with a clean cloth
or blow it with compressed air at low pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
Anl_GP_LB_36_230_Li_E_BL_SPK13.indb 16
Anl_GP_LB_36_230_Li_E_BL_SPK13.indb 16
GB
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
7.2 Maintenance
•
Should the tool experience problems beyond
those mentioned above, let only an authorised
professional or a customer service shop per-
form an inspection.
•
There are no other parts inside the equipment
which require maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Faults
The equipment does not work:
Check that the battery is charged and that the
charger is working. If the equipment will not work
in spite of the voltage supply being OK, please
send it to the customer service address provided.
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should be
taken to a suitable collection center for proper dis-
posal. If you do not know the whereabouts of such
a collection point, you should ask in your local
council offi ces.
- 16 -
24.10.2024 08:27:18
24.10.2024 08:27:18
Publicité
