HIKOKI CL 14DSL Mode D'emploi page 15

If there is breakage or warping on the cutter edge or if
there are bulges on the cutter attachment surface, use
a fi le to the areas fl at.
Use brush to remove the fi lings attached to the cutter
attachment groove on the bracket.
CAUTION
As shown in Fig. 20, if the cutters are combined in such
a way that both side without the notch on the cutter or
both notch sides are facing out, the pitch of the threads
on the studs and the threads on the cutter will not be in
agreement. This can cause damage to the cutter edge
or cause wear to premature damage to the main unit.
Both on
notch side
DON'T
Size
M10
M8
M6
W3/8"
CAUTION
Use special cutters and spacers that conform with the size of the stud. Using cutters and spacers of the wrong size or
confusing them can lead to damage to the stud and cutter.
Both on
side without
notch
Fig. 20
(4) Attachment
When using an M6, M8 or M10 cutter
Insert the cutter in the cutter attachment groove on the
bracket, insert the special spacer between the cutter
and the bracket and then use the hex. socket hd. bolt to
tighten and secure.
When using the W3/8" cutter
Insert the cutter in the cutter attachment groove on the
bracket and then use the hex. socket hd. bolt to tighten
and secure.
NOTE
Spacers are not required when using the W3/8" cutter.
CAUTION
The hex. socket hd. bolt should be suffi ciently tightened
with the hexagonal wrench.
Bracket (A) Spacer
Hex. socket hd. bolt
Cutter Spacer
Bracket (A)
Hex. socket hd. bolt
Cutter
Attachment
Cutter
Hex. socket hd. bolt
Bracket (B)
Cutter
Hex. socket hd. bolt
Bracket (B)
English
15