HIKOKI CL 14DSL Mode D'emploi page 14

English
8. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig. 14)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The Table 4 shows the state of remaining
battery indicator lamp and the battery remaining power.
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power is a half.
The battery remaining power is nearly
empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
○ Do not give a strong shock to the switch panel or break
it.It may lead to a trouble.
○ To save the battery power consumption, the remaining
battery indicator lamp lights while pressing the
remaining battery indicator switch.
CUTTER LIFE AND REPLACEMENT
1. Cutter life
As is shown in Fig. 16, repeated cutting can cause
breaking and warping of the cutter edge. Using the
cutter in this condition can produce fl ange on the cutting
location of the studs so that the threads are distorted.
This will prevent clean cuts and make it impossible to
insert the nut.
Breaking
14
Table 4
Warping
Fig. 16
As is shown in Fig. 17, the edge is found on four
locations on the cutter. Use the method described
below to change the attachment direction of the cutter
to allow a total of four usages.
If the nut does not fi t on the screw due to breaking and
warping of the edge, change the cutter attachment
direction to use the edge without breaking and warping
or replace with a new cutter.
Four edges
on the cutter
2. Changing the cutter attachment direction or
replacing the cutter
(1) Before removing:
Pull the trigger switch and move bracket (A), stopping
with the cutter in the open position.
Set the forward/reverse switching button to the lock
position (Fig. 4 (b)).
Remove the rechargeable battery from the main unit.
(2) Removal
Use the accessory hexagonal bar wrench to remove the
hex. socket hd. bolt. It is now possible to remove the
cutter and spacer.
(3) Before attaching
There are four edges on the cutter. As shown in Fig. 18,
by changing the position of the edge it is possible to use
the blade four times.
( ) (
Turning to the Turning to the
back side back side
1st time 2nd time
There is directionality for cutter attachment in order to
change the position of the edge. Check that the cutter
has been attached so that the side without the notch on
the cutter can be seen on bracket (A) (movable side)
when seen from the main unit viewed from the front or
that the notch on the cutter surface on bracket (B) (fi xed
side) can be seen (Figs. 5 and 19).
Fig. 17
)
( ) (
Turning to the
Re-insertion
back side
3rd time 4th time
Fig. 18
Side without notch
Notch side
DO
Fig. 19
)