Cleaning And Maintenance; Technical Specifications - HQ Power VDL400SM2 Mode D'emploi

Masquer les pouces Voir aussi pour VDL400SM2:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

6.
Use
Refer to the illustrations on page 2 of this manual.
1. Connect the device to the mains [6] and flick the power switch [7] at the back of the device to ON. After
the warm-up time (approx. 4 minutes) the device is ready for use. The red indicator light [4b] is now lit.
2. Activate/deactivate the smoke output with the push button [4a].
3. It may happen that the standby lamp on the controller [4] is off and the smoke emission stops, even while
you are holding the button. In this case the device is warming up again and will be ready to resume
operation in a few minutes' time. This process guarantees an appropriate vaporisation temperature and the
best smoke emission possible.
7.

Cleaning and Maintenance

All screws should be tightened and free of corrosion.
Mechanically moving parts must not show any signs of wear and tear.
The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
Disconnect the device from the mains prior to maintenance activities.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
There are no user-serviceable parts, apart from the fuse (see 5. Installation).
Contact your dealer for spare parts if necessary.
Clean the heating element after every 30 hours of use with a special cleaning liquid available from your
dealer. Fill the tank with the cleaning liquid and let the machine run for a while. When the device is cleaned,
remove the remaining cleaning liquid and rinse the tank thoroughly with distilled water. Never use regular
water for cleaning or rinsing!
8.

Technical Specifications

power supply
power consumption
fuse
smoke output
warm-up time
tank capacity
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulted from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.hqpower.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
V. 01 – 19/01/2015
VDL400SM2
max. 230 V~, 50 Hz
max. 400 W
F 3A, 250 VAC (5 x 20 mm) (order code FF3N)
70 m³/min.
approx. 4 minutes
0.3 litres
230 x 110 x 110 mm (without bracket)
2 kg
5
©Velleman nv

Publicité

Table des Matières
loading

Table des Matières