Closing The Door; Installation; Electrical Connection - AEG AGS77200F0 Notice D'utilisation

26 www.aeg.com
Problem
Upper or lower
square is shown in
the temperature dis-
play.
dEMo appears on
the Display.

6.1 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

7.1 Positioning
WARNING!
If you are discarding an old appli-
ance that has a lock or catch on
the door, you must ensure that it
is made unusable to prevent
young children being trapped in-
side.
The appliance shall have the
plug accessible after installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
Products are too near to
each other.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
3.
Cli-
mate
class
SN
N
ST
T

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
Solution
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Store products so that
there is cold air circulation.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start
works regularly.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C